DynamicSignals / GaGe CompuScope 1602-8M PCI Bus Ultra-Fast Waveform Digitizer Card
  • DynamicSignals_GaGe_CompuScope_1602_8M_View1_2019101095942
  • DynamicSignals_GaGe_CompuScope_1602_8M_View2_2019101095942
  • DynamicSignals_GaGe_CompuScope_1602_8M_View3_2019101095942

DynamicSignals / GaGe CompuScope 1602-8M PCI Bus Ultra-Fast Waveform Digitizer Card



Configuration:

• 8 MB Memory
• CP500 Cutout Base Board
• CS 8500/PCI Expansion Memory Daughtercard
• Master Multi-Card Upgrade, Part Number 162-181-006

Part Number: 162-001-003




Have a quote from somewhere else? Click Here
Stock # 79284-1
Quick Quote
Sell Yours
Repair Quote
  • More Info
  • Tech Specs
  • Additional Photos
  • Datasheets / Manuals 
  • View It Live Request 
Contact Us
Share:
DynamicSignals / GaGe CompuScope 1602 Series PCI Bus Ultra-Fast Waveform Digitizer Card

Features
  • 16 bit, 2.5 MS/s A/D Sampling on Two Simultaneous Channels
  • Differential or Single-Ended Inputs
  • Up to 1 GigaSamples of On-Board Acquisition Memory
  • 75 dB Signal to Noise Ratio
  • Multi-Card Systems of up to 16 Simultaneous Channels at 2.5 MS/s
  • Fast Data Transfer Rate to System RAM

Description

The DynamicSignals / GaGe CompuScope 1602 Series PCI Bus Ultra-Fast Waveform Digitizer Card can simultaneously sample two analog signals at speeds up to 2.5 MS/s with 16 bit resolution and store the data in the on-board memory.

CompuScope 1602 uses state-of-the-art data conversion technology to provide dual-channel simultaneous sampling rate of 2.5 MS/s with 16 bit resolution. Each channel has its own ADC chip, eliminating the need for multiplexing the inputs.

Differential inputs allow the user to fully exploit the 16-bit A/D of the CompuScope 1602. Differential input circuitry automatically eliminates noise picked up by the signal and its reference. With over 80 dB CMRR (Common Mode Rejection Ratio) for low frequency inputs, differential inputs eliminate any ground loop problems. Single-ended inputs are also available through a simple software command. This command simply connects the negative input of the differential pair to zero volts, allowing single-ended operation.

In order to isolate the high-frequency analog circuitry from PCI bus-related digital electronics, a two-board piggyback configuration is used. This allows maximum separation of analog and digital grounds, thereby providing high immunity to digital noise.

CompuScope 1602 has memory depths of 1M, 4M, 8M, 64M, 256M, 512M and 1G (16-bit samples). This memory can be used as a circular buffer for storage of pre- and post-trigger data. Memory is divided equally between the two input channels, i.e. a 1 Meg board provides 512 Ksamples of memory per channel. The data stored in the CompuScope 1602 memory can be transferred to the system RAM for post-processing, display or storage to hard disk without any interface bus (no GPIB bus required).

CompuScope 1602 features flexible, oscilloscope-like analog triggering. An analog comparator provides triggering from any one of the two input channels, from an external signal or from software. In addition to the trigger source, trigger level and slope are also selectable by software, making the trigger system similar to traditional oscilloscopes.

CompuScope 1602 uses a unique architecture to provide 16-bit resolution. The input signal is over-sampled by a factor of 8 and the resulting data stream is fed into an on-chip decimation filter and error-correction circuitry which enhances the effective resolution and dynamic range by eliminating high frequency noise and by providing the lower order bits of the digital output.

Even though the PCI bus allows very fast data throughput to system RAM, there may still be applications in which data bursts cannot be off-loaded either due to very fast trigger repeat frequency or due to software limitations. Multiple Recording allows CS1602 to capture data on successive triggers and stack it in the on-board memory. Up to 4,194,304 triggers can be captured in multiple record mode. Once the CompuScope 1602 finishes capturing a Multiple Record segment, the trigger circuitry is automatically re-armed within 5 sample clock cycles to start looking for the next trigger - with no software intervention.


Product Family: CompuScope 1602, CompuScope1602, CompuScope-1602


Important Notice: Please note that any additional items included with this equipment such as accessories, manuals, cables, calibration data, software, etc. are specifically listed in the above stock item description and/or displayed in the photos of the equipment. Please contact one of our Customer Support Specialists if you have any questions about what is included with this equipment or if you require any additional information.


Contact Us
Share:

Specifications

Contact Us
Share:

Item Images

Click a thumbnail to view larger image:

DynamicSignals / GaGe CompuScope 1602 Series PCI Bus Ultra-Fast Waveform Digitizer CardDynamicSignals / GaGe CompuScope 1602 Series PCI Bus Ultra-Fast Waveform Digitizer CardDynamicSignals / GaGe CompuScope 1602 Series PCI Bus Ultra-Fast Waveform Digitizer Card


Contact Us
Share:

View It Live

View equipment LIVE - Before you buy!

InstraView™ Equipment Inspection



Buying used equipment doesn't always have to be a shot in the dark. We know there are plenty of differences when it comes to used equipment and quite often, choosing between different pieces is difficult, especially when the equipment is not sitting right in front of you.

Well, what if you were able to see a piece of equipment before you purchased it? Not just a picture from the manufacturer's website, but the actual piece of equipment you would receive.
With InstraView™, we move you one step closer to inspecting the equipment you're interested in without having to wait for the equipment to show up at your door.

InstraView™ works in your web browser and allows you to view the actual piece of equipment you're interested in before purchasing. You can zoom in close to see the labels with the serial number or zoom out to see the overall condition of the equipment.

It's like having the store come to you!


InstraView Request Form

To get started:

  1.   Fill in the request form below
  2.   We'll send you an email letting you know exactly when your piece of equipment will be available for viewing

Name:
Email:
Item to Inspect: 79284-1 - DynamicSignals / GaGe CompuScope 1602-8M PCI Bus Ultra-Fast Waveform Digitizer Card


All you need is a web browser (ie. Microsoft Internet Explorer or Netscape) and Sun's Java Runtime Environment installed. If you need to install the Sun Java Runtime, you may download the latest Java SE Runtime Environment (JRE) http://www.oracle.com/technetwork/java/javase/downloads/index.html