National Instruments PXI-8464 Series Controller Area Network (CAN) Interfaces
  • national_instruments_pxi_8464_2_view1_201612291034
  • national_instruments_pxi_8464_2_view2_201612291034
  • national_instruments_pxi_8464_2_view3_201612291034
  • national_instruments_pxi_8464_2_view4_201612291034

National Instruments PXI-8464 Series Controller Area Network (CAN) Interfaces

Features

  • Philips SJA1000 CAN Controller and ISO 11898 Physical Layer
  • 100 Percent Bus Load Receiving Capability up to 1 Mbit/s
  • Hardware Timing for Accurate Timestamping and Synchronization
  • High-Speed, Low-Speed, or Single-Wire Transceiver Selected in Software

View our selection of these items below.


Have a quote from somewhere else? Click Here




Contact Us
Share:



This National Instruments PXI-8464/2 Dual Port CAN Interface is used and in excellent condition.

This is a Series 2 card

Configuration:
• (2) 9-pin D-Sub Connector
• Software-Selectable CAN
• Max Transfer Rate 1000 (kb/s)

Part Number: 189066B-42, 778783-02



Stock # 55283-16




Part Number: 186855C-01

Product Family: NI-DNET, PCMCIA-DNET, Device Net, DeviceNet

NI forums has the following information regarding the PSH15-C6:
Q: "Must I connect V+ in my low speed port (CAN/DS) if i use a PCMCIA CAN/2?"

A: "You must have the Two port low speed cable adapter, part number: 186855C-01. In this cable the transceiver is internally powered, so there is no need to power the transceiver from the bus."



Stock # 55024-96




This National Instruments PXI-8464/2 Dual Port CAN Interface is used and in excellent condition. This is a hybrid-slot compatible PXI module that can be used in both PXI Express hybrid slots and standard PXI slots.

This is a Series 2 card

Configuration:
• (2) 9-pin D-Sub Connector
• Software-Selectable CAN
• Max Transfer Rate 1000 (kb/s)

Part Number: 189066C-42, 778783-02



Stock # 55283-39



  • Description
  • Tech Specs
  • Datasheets / Manuals 
Contact Us
Share:

Description

The National Instruments PXI-8464 Series Controller Area Network (CAN) Interfaces are a 2-port transceiver-selectable controller area network (CAN) interface designed for communicating with high-speed, low-speed, or single-wire CAN devices. The appropriate transceiver for each port is selected in a configuration utility or in the application. NI CAN modules for PXI use the Philips SJA1000 CAN controller for advanced functionality such as listen-only, self-reception (echo), and advanced filtering modes and use new transceivers for sleep/wake-up mode. You can synchronize CAN, data acquisition (DAQ), vision, and motion modules using the PXI trigger bus. All National Instruments CAN interfaces are designed to meet the physical and electrical requirements for in-vehicle (automotive) networks based on CAN.

What are the differences between the Series 1 and Series 2 CAN boards?
Series 1 boards could communicate by either DeviceNet or CAN, but for Series 2 this functionality was separated into different products. Because of this, Series 1 cards require an older version of the NI-CAN driver to be used since Series 2 phased the Series 1 cards out.

Product Family: PXI-8464/2, PXI 8464/2, PXI8464/2
Contact Us
Share:

Specifications