National Instruments NI 9237 C Series Strain/Bridge Input Module
  • national_instruments_9237_view1_20171129172041

National Instruments NI 9237 C Series Strain/Bridge Input Module


  • (4) Channels, 50 kS/s Per Channel Simultaneous AI
  • ±25 mV/V Input Range
  • 24-Bit Resolution
  • Programmable Half- and Full-Bridge Completion

View our selection of these items below.

Have a quote from somewhere else? Click Here

Contact Us

This unit is sealed in the original manufacturer's box.

Part Numbers: 779521-01, 198859B-01L

Stock # 93998-1

  • Description
  • Tech Specs
  • Datasheets / Manuals 
Contact Us


The NI 9237 C Series Strain/Bridge Input Module is for use with CompactDAQ and CompactRIO. It contains all the signal conditioning required to power and measure up to four bridge-based sensors simultaneously. The four RJ50 jacks provide direct connectivity to most torque or load cells and offer custom cable solutions with minimal tools. The high sampling rate and bandwidth of the National Instruments 9237 offer a high-quality, high-speed strain or load measurement system with zero interchannel phase delay. With 60 VDC isolation and 1,000 Vrms transient isolation, the National Instruments 9237 has high-common-mode noise rejection and increased safety for both the operator and test system.

The National Instruments NI 9237 can perform offset/null as well as shunt calibration and remote sense, making the module the best choice for strain and bridge measurements.

The National Instruments NI 9944 and NI 9945 are accessories for use with quarter-bridge sensors. These accessories have a female RJ50 connector on one end and screw terminals on the other end.

Product Family: NI 9237, NI-9237, NI 9944, 9944, 9945, NI 9945
Contact Us