MS CU Scienta Omicron Micro Slide Control Unit

The Scienta Omicron / Omicron MS 5 Micro Piezo Slide is based on the principle of inertia drives employed in Scienta Omicron / Omicron's Scanning Probe Microscopes. It provides a highly compact and effective means of achieving accurate positioning without the necessity for complex and sensitive mechanical couplings.

The MS 5 only requires electrical connections and thus minimizes thermal and vibration isolation problems while allowing for user-friendly remove control of the device even under difficult boundary conditions. The MS 5 can also be used under ambient conditions in fields such as precision optics, micro-engineering, micro-structuring, nanolithography and other applications where a precise, backlash-free positioning of samples, detectors, apertures, shutters, lenses, scanners and other devices is essential.

The MS 5 piezo-electrically driven linear stepper motor incorporates specially designed guides and a pre-loaded construction to ensure guaranteed backlash-free movement with optimum repeatability. The MS 5 Micro Piezo Slide is fully UHV compatible and bakeable to 180°C.

The step size can be continuously varied between 40 nm and 400 nm, with a maximum travel of 5 mm. The load bearing capacity in the horizontal position is 300 g. The lifting capacity in the vertical orientation is approximately 50 g (tractive force 0.5 N). Extensive laser interferometer tests demonstrated a high repositioning accuracy with a lateral run-out of better than +/- 20 nm. The MS 5 can be operated in any orientation. Up to three Micro Piezo Slide units can be easily combined to provide precise control of independent movement in three dimensions as an x/y/z-axis position device. Locating pins are utilized to ensure precise orthogonal alignment of the units.

The versatile MSCU control unit allows for easy and precise operation of up to three individual MS 5 units, using a remote control handset. Automatic control by means of a computer or an external signal generated by TTL logic modules is also possible.

The speed of movement of the Micro Piezo Slide can be controlled over a wide range, from a single 40 nm step to continuous movement operation driven at frequencies of 4, 3, 2, 1 or 0.5 kHz. The unit can be equipped with a UHV feedthrough and UHV compatible wiring. Electrical connections to the Micro Piezo Slide consists of one connection per axis plus an additional terminal for the ground wire.