818-F-IR Newport Fiber Optic Detector Module 780-1800 nm with 818-FA3-FC Fiber Adaptor

The Newport 818 Series Low-Power Detectors uses the highest quality semiconductor detector materials available.

The 818 Series Cylindrical Detectors (818-UV, 818-SL, 818-IR, 818-IG) are offered for broad wavelength ranges covering UV, visible, near-IR, and IR regions. They use the finest large-area planar-diffused PIN silicon, indium gallium arsenide, germanium PIN or inverted-channel silicon detectors. Each is optimized for zero-bias operation to provide the low noise, high stability and uniformity demanded by critical radiometric measurements. Compact packaging, international mounting holes and BNC-terminated cabling make incorporation into experimental, production and field applications straightforward.

The 818-F Series Fiber Optic Detector Modules are optimized for measurements on connectorized fiber optics. These compact detector modules allow the connection of an optical fiber directly to the meter, configuring it as a dedicated fiber optic power meter. These detector modules are only compatible with Newport meters that support the /CM detector option. They are not BNC- terminated.

Exclusive OD3 attenuator technology extends the calibrated optical dynamic range of the Cylindrical and Hand-Held Wand Detectors by three decades. The patented attenuator design provides low reflection, high damage threshold and spectral flatness, without the damage susceptibility problems of thin-film attenuators or the spectral variance of simple volume- absorbing attenuators

Calibration modules are required when using Cylindrical and Hand-Held Wand Detectors with Newport’s Model 840-C, 1830-C, 1835-C, 2832-C, 2835-C or 4832-C optical meters. The module is matched to an individual detector and provides the meter with detector calibration and operating information. The calibration module option is indicated by the /CM suffix in the detector Model number.

When using Cylindrical or Hand-Held Detectors with Newport's 841-PE Power/Energy Meter, a DB15 connector with EEPROM is required. This option is indicated by the /841 suffix.