IN3252HR INLINE 1-In 2-Out RGBHV Distribution Amplifier / Line Driver

The INLINE IN3252HR 1-In 2-Out RGBHV Distribution Amplifier / Line Driver is designed to amplify and split one RGBHV signal to two data monitors, data projectors, or other RGBHV compatible output devices. The IN3252HR offers extremely wide bandpass characteristics, ensuring compatibility with analog video signals at any resolution and refresh rate. While specifically designed for RGBHV signals, the unit may also be used with RGBS, RGsB, component, Y/C and composite video signals such as NTSC, PAL, or SECAM. A set of five BNC connectors located adjacent to the input connectors provides a High Z passive loop-through signal. This can looped through one or more additional IN3252HR amplifiers to create a larger DA system or connected a local monitor.

Capable of increasing signal voltage by up to 40%, the IN3252HR also functions as a line driver, allowing video signals to be sent down longer cables than would be possible without amplification and equalization. Actual maximum drive distance depends on the resolution of the video signal and is largely determined by the bandwidth of the cable used for input and output connections. Individual Gain Controls for Red, Green and Blue permit gray scale adjustment and also offer signal boost to compensate for video signal amplitude losses caused by lengthy cable runs. Proper gain control adjustment will result in improved image contrast. The controls have an adjustment range of 0.7 (30% decrease) to 1.4 (40% increase). A single control adjusts the sharpness for the RGB output signals. This control can be adjusted to enhance the appearance of high resolution video signals by increasing apparent clarity and boosting the visibility of fine details. The sharpness control also compensates for the high frequency loss occurring in long cables