This GE Fanuc Genius 115 VAC 8 Circuit Grouped I/O Block is used and in good condition. Unit is missing face plate.
Configuration
• Electric Assembly: IC660EBD100B
• Terminal Assembly: IC660TSD100B
Show More Description
Important Notice: Other accessories, manuals, cables, calibration data, software, etc. are not included with this equipment unless listed in the above stock item description.
Features:
- Output Pulse Test Capability
- Selectable Input Filter Time from 10mS to 100mS
- Output Powerup Defaults
- CPU Redundancy Type
- Bus Switching Module Control
The GE Fanuc Genius 115 VAC 8 Circuit Grouped I/O Blocks have one group of 8 discrete circuits, rated to operate at a nominal 115 volts AC. Each circuit can be an input, a tristate input, or an output.
Control power for the block is tapped off the input/output device voltages wired to the terminals. No separte block power supply is needed.
Each circuit has electronic fusing that shuts down the circuit in 5µS if output current exceeds 30 amps at turnon, or 20 amps after 2 cycles. The circuit is easily restored by command from a hand-held monitor or the CPU. Fault reporting can be enabled or disabled circuit-by-circuit.
This block is fully compatible with Hand–held Monitor model IC660HHM501. It may be used with IC660HHM500. However, HHM501 is required to change baud rate configuration, or to configure the block for redundancy. The blocks may be used with any GE Fanuc bus controller, PCIM or QBIM module.
This block is backward compatible with blocks IC660CBD100 and IC660BBD100, and may be used to replace them. Electronics Assembly IC660EBD100 replaces Electronics Assembly IC660ELD100. Electronics Assembly IC660EBD101 replaces both IC660ELD100 and IC660EBD100.
Terminal Assemblies IC660TSD100E and later are not compatible with earlier versions of the Electronics Assembly. If the Terminal Assembly will be used to replace Terminal Assembly IC660TSD100D or earlier, the Electronics Assembly must be either replaced with version IC660EBD101F or later.
Artisan Scientific Corporation dba Artisan Technology Group is not affiliated with or a distributor for GE Fanuc. The depiction, description, or sale of products featuring names, trademarks, brands, and logos is for identification and/or reference purposes only and does not indicate any affiliation with or authorization by any rights holder.
Highly technical staff! Excellent customer service!
Staff knows their stuff! Very knowledgeable and helpful. Very satisfied!
These people are amazing and absolutely *outstanding* at what they do. The customer service is terrific, every product is shipped to the exact specifications I ordered, and everyone has consistently bent over backwards to help me. They also carry a wide range of products and offer exceptional support. Very highly recommended!!!
Don’t worry about damage to your items during shipping – the box ours came in could have taken a beating and would have still survived!